Contact Us

Contact: Jordan Tang
Tel: +86-21-63161632
Mobile: +8613918216784
Whatsapp: +8613918216784


Service Hotline


Home > NewsContent

Auto Clutch Installation And Adjustment Procedures

Shanghai ET Auto Parts Co.,Ltd | Updated: Sep 14, 2016

Clutch pedal is stepped on, but gear trouble, gear crash. If too thick spacer between the clutch cover and flywheel. For the hydraulic clutch, in addition to the above checks, you should also check the brake fluid is missing, the air in the hydraulic system of pipeline leakage and discharge. Check that the clutch pedal free travel is excessive and adjust. Check the release lever height is consistent, if too low. 

Under the car struck separate fork, bearing front gently against the release lever on the inner surface, turn the clutch for a week for viewing, if separate inner end of the lever and release bearing contact is not at the same time, the separation of leverage highly inconsistent, should be adjusted. For new rivet clutch friction plates, to check whether the driven plates and friction discs too thick. If the release lever that degree of consensus, still incomplete separation, check the lever height. Set the release lever to the same height, if completely separated, the original improper adjustments or wear what. Release lever adjustment, readjust the clutch pedal free travel. If the above adjustments to normal, still incomplete separation, it is necessary to remove clutch, check whether the driven plates reversed, whether the axial movement difficult, and driven plates with or without warping, release lever screw is loose, floating PIN is off.